Rectal cleaning hydrodouche bathmate

The hydrodouche from bathmate is the modern anal douche. methods of employing the hydrodouche make sure the flow regulator is fully depressed in the off position and the hydro wand is standing vertically in the holder before using the hydrodouche. go ahead and turn on the shower and adjust the temperature to your liking. fill the hydro chamber up to the brim with water. take the hydro wand out of its cradle and hold it so that the nozzle is pointed down; then, with the regulator open all the way, water should be able to flow freely through the hose, forcing out any air. when a constant stream of water is being produced, the water temperature should be checked and the flow regulator set to the desired level. make sure there's enough water in the chamber for its intended purpose, and add more if necessary. a steady flow can also be achieved by installing the shower head above the chamber. putting together a hydrodouche it's important to construct the hydrodouche properly so that it can perform optimally. misuse and improper assembly can void the warranty and produce subpar results. what's in the hydrodouche? - an adaptable locking strap hydro chamber, chamber connector, hose, flow regulator, hydro wand connector, and hydro wand hydrodouche assembly begins with attaching the mounting bracket to the hydro chamber; this bracket may be flipped to move the hydro wand holder to the left or right side of the hydro chamber. be careful not to get your finger stuck between the inside of the bracket and the chamber as it will snap firmly into place. connect the strap to the bracket by threading it through the hole. find a good spot for the chamber assembly in the shower, keeping in mind that it must be lower than the shower head for filling, and that the water pressure from the hydro wand nozzle will increase with height. tighten or loosen the strap as needed. carefully screw the hydro wand onto the wand connector, taking care not to overtighten or cross the threads, and set the wand into its bracket. join the chamber assembly with the chamber connector in a similar fashion. connect the chamber connector to the wand connector and then feed the hose through the flow regulator. the regulator can be attached to the hose in whichever orientation is most comfortable for the user. the hose can be easily attached or detached by pushing or pulling on the connector between the wand and the chamber. you can begin using your hydrodouche immediately. preventive upkeep and cleaning the hydrodouche should be taken apart after each use, washed in warm soapy water, and then rinsed well. assure that the water in the hose has completely drained and that the flow regulator has been disconnected. put it somewhere dry and out of the sun to dry completely. the hydrodouche does not require any upkeep when used normally; but, after extensive use, the clear hose may start to look a little dingy. this occurs naturally and poses no danger whatsoever.